open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello,

I had to rebuild my computer and I'm reinstalling all programmes.
At the moment I have problems to install Fudaa Prepro. During the download appears the message that the digital signiture has an mistake and that the aplication can't be executed. It says that there is a unsigned input in the ressource. What could be the problem? Is there a wrong setup in my system?

Thanks in advance.

Andrea

helloandrea,
please download fuda pre pro 1.1.0 from sourceforge net and be sure to instal java in your machine. Then fuda should work fine.But can you tell me how to instal telemac v6p1 in compiled version in scalar mode? I have been searching for right answer but not getting any clarification.when extracted a setup file is ready to self instal but when installed it's not functioning via fuda. Can you suggest where i am going wrong..thank you

prabir

Thank you for your hint. It worked.
Respect to the installation of telemac, have you installed Perl before correctly? I installed Telemac via the compiled version (download Setup_Telemac_v6p1_windows_intel) some days ago and it worked. I didn´t even had to modify the environmental variables. Have you followed the instructions?
Hope that helps.

Andrea

Hi Andrea,
thanks for your reply.Yes..I had pearl installed and tested that it worked by typing pearl -v. Then please clarify what next to instal that setup telemac v6p1 windows intel in windows xp 32 bit.When downloaded and extracted ,I got setup_V6P1.exe.Please tell me just after this point what are next steps. There is no clear instruction in installation page for this mode.So I request you now to tell step by step. I am getting confused with instructions as it is written for all types together. Hope for your quick reply.

prabir

Hello Andrea,
I again just tried as per your previous advice. But when I try to run through Fuda it says 'windows can not find telemac2d.bat'. On checking however i find it inside c\telemac\v6p1\bin directory. Where is the problem and how to fix it. please reply soon.So may be you can give me a step by step guidance to instal it. As you have recently done just this same version in windows ,i think you are the right person .thanks



prabir

Hello Prabir,

after unpacking the zip file, you can save the whole program structure on C:\\.
You have to check if the systel.ini file is under the folder config. Otherwise download it and put it there. Besides check the environmental variables $PATH, if there exists the bin folder of Telemac and of Pearl. And check if the variable $SYSTELCFG exists.
You can use a tutorial case for trying to run it on Fudaa. Get to the Cas File and start the simulation.
These are the hints I know, hope it helps.

Andrea