TELEMAC-MASCARET Forum: Velocity viewer in PostTelemac (QGIS) (2/2)

Welcome, Guest

Page:
1
2

TOPIC: Velocity viewer in PostTelemac (QGIS)

Velocity viewer in PostTelemac (QGIS) 7 years 7 months ago #25984

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	You should zip it before joining it and the size should be lower than 2Mo...
	Christophe The administrator has disabled public write access.

Velocity viewer in PostTelemac (QGIS) 7 years 7 months ago #25987

Schmirre OFFLINE Senior Boarder Posts: 78 Thank you received: 1	Still couldn't upload it - anyway here's a link: drive.google.com/drive/folders/0By1HqyUX...WaDhvNHM?usp=sharing hope it works :)
	The administrator has disabled public write access.

Velocity viewer in PostTelemac (QGIS) 7 years 7 months ago #25991

Schmirre OFFLINE Senior Boarder Posts: 78 Thank you received: 1	Thank you for your support, but I managed to solve the problem. As always, you feel very stupid when you realise that the solution is simple. I had a different reference coordinate system (it's not changed automatically by default in QGIS I guess). That explains why the vectors were unable to be displayed. Thanks for paying attention though! All the best, schmirre!
	The administrator has disabled public write access.

Velocity viewer in PostTelemac (QGIS) 7 years 7 months ago #25992

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	That's it! We didn't manage the display when the display coordinate system is not "metric". Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: Schmirre

Velocity viewer in PostTelemac (QGIS) 6 years 3 months ago #31226

Schmirre
OFFLINE
Senior Boarder
Posts: 78
Thank you received: 1

Hi again!

I have a new problem this time, which I hope you might be able to help me with..

I am trying to visualise current velocity with PostTelemac. Even though my settings are set to "Show all points", not all points are shown. In areas with low velocity, the nodes are simply excluded.

Do you know what might be the matter with this?

If not, I'm trying to extract the data as .shp with the tool ToShape/PointCreation/velocity vector creation , to simply visualise them myself. But the attribute table give two new rows, norme (in both positive and negative values) and angle (with a unit I can't understand).

Thanks in advance!

/schmirre

The administrator has disabled public write access.