open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi all,

I have been testing the new version v7p2r0 and found an error in the "fo1_bridge.txt" culvert data file. Haut2 is set to 0 (unlike Haut1 which has the value 1,5) which means that the culvert discharge is forced to 0 m3/s by the following test in buse.f:

IF(HAUT1.EQ.0.D0.OR.HAUT2.EQ.0.D0) Q=0.D0

I guess it is a simple mistake since the structure of the culvert data file is new from this version.

Best regards
PL

Hello,

You are right there is a mistake with the "fo1_bridge.txt" data file, HAUT2 should be equal to 1.5. Also the new parameter LBUS is a linear head loss coefficient, and I had mistaken it for the length of the culvert (just called length). I just fixed it in the trunk and it will be part of the next minor release (V7P2R1).

Best regards,
Agnès