open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello everyone
I have a selafin file of initial water surface position over the whole mesh. However, some areas within this area are dry and have bottom elevations higher than the surrouding water elevations. Few seconds after having run the simulation, I got this error (Can not compute the water heights)
Of course this case leads to some negatives water depths (dry areas), but theoretically Telemac handles this issue (dry zones).
Is there any tips to overcome this?
Any remark or suggestion will be appreciated
With regards

Hello Mourad

This can not be the problem that causes the crash of your model. Try to investigate more in order to identify the real issue.
You can run with a debug mode (keyword DEBUGGER=1) and see when telemac stops.

with my kind regards

Riadh