TELEMAC-MASCARET Forum: problem with entering flow and exit flow (1/1)

Welcome, Guest

TOPIC: problem with entering flow and exit flow

problem with entering flow and exit flow 6 years 3 months ago #31187

joshgir

Hello everyone,

I am modelizing a river with a junction and I have 3 different boundaries. However, the water doesn't flow in the correct direction. I attached the geometry, the .cli, .liq, and the .cas. The water is supposed to flow from the south to the north on the image.
If one of you knows why this doesn't work, let me know :)

Attachments:

Athabasca_...8-08.cli (471KB)
Athabasca_...ady2.cas (4KB)

The administrator has disabled public write access.

problem with entering flow and exit flow 6 years 3 months ago #31188

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi You probably made an error in the numbering of liquid boundary. According to your cli file, there is SL(1), Q(2) and Q(3) In your steering file you give velocity profile = 5,5,1 which is not conform to the liquid boundary... I think this should be 1,5,5 So probably same error in the liquid file which is not attached Hope this helps
	Christophe The administrator has disabled public write access.