open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear friends,
There is a strange problem bothered me. I am running a meandering river model with Telemac2d. Strangely, in the results, there is a strange water depth results in the curved top. The Water depth in a point is even more than 70m. However, all the other water depth value is lees than 1m.
I attached to figures to show my results. The first one is my mesh with the strange node location, and the second show my results of water depth from high to low.
I have checked the bottom and tried more than three times, but still do not know what mistakes I have made.
Could you give me some suggestion?
Best wishes.
Fakai Lei

Hello,

I suppose you created the file with Blue Kenue. After you perform the 2-D interpolation are the values created on the FOND mesh ok in that node? Have you checked your .xyz file for the values located near this node?

Kind regards,
Andreas

What about the bottom elevation, water surface elevation, and velocity vector at the node? Do they make sense?

Hailiang