open TELEMAC-MASCARET The mathematically superior suite of solvers

hello
When I put this coefficient down to my area of 0.7
COEFFICIENT TO CALIBRATE SEA LEVEL : 0.7
I can not see the output as an animation And I get the correct time series for free surface
But when I put this switch 2
COEFFICIENT TO CALIBRATE SEA LEVEL : 2
I can see the output as an animation
And the time series is displaced on the y axis
And I do not see the difference between peak height.
Which has a green output for the value of 2 and a red output of 0.7
Who can help me know where the problem is
And with 0.7 I can not see the output animation
The correct amount for my region is 0.7
regards

Hi
I think this is two different problems.
Coefficient to calibrate sea level should probably be 0.7 in your case
As the simulation seems to run well (there is evolution in time of the water level) the animation of results is just a problem of post processing.

Be sure to right click on the result layer and select animate in BK.
this should be done for each layer in the 2D view...

Hope this helps

Regards