open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello
I previously had a v7p0 version of the telemac software and I could specify PARALLEL PROCESSORS but recently I installed the v7p3 version and I can not set the PARALLEL PROCESSORS to more than 1 and I get an error. what is the reason? What should I do to solve this problem?
Regards

Hello

The error message is explicit, your configuration (wingfors) is a scalar configuration.
You have to change it to a parallel configuration. to do so, change your config.cfg file by the one that uses wing64mpi that you can find here
drive.google.com/file/d/0B8AKbPZw82vQODJ...Y3c/view?ts=59ca5a6b
and then recompile the system.
as a final spep, you have to register MPI. These steps can be found in the installation section.

kind regards

Riadh

thanks for your response
I followed your rule, but I got the error again. I use the v7p3r1 version of the telemac.

Hi
Try to read the error message before posting.
This clearly indicate a problem with the folder name which probably means you didn't configure the parallel version in the wing64mpi.cfg file

As you wrote it was working before with v7p0, you already tune the configuration file once to let the v7p0 works...

Try to look what you've done in v7p0 config file and try to adapt the v7p3 in a similar way

Regards