TELEMAC-MASCARET Forum: TIDE (1/1)

Welcome, Guest

TOPIC: TIDE

TIDE 5 years 11 months ago #32288

nadi
OFFLINE
Junior Boarder
Posts: 37

Hello
I am modeling the tide in the Persian Gulf.
I calibrated my model by using a few options(TIME STEP-COEFFICIENT TO CALIBRATE TIDAL RANGE-COEFFICIENT TO CALIBRATE SEA LEVEL-FRICTION COEFFICIENT).
The see level was similar to measurement, but the velocity and observation values were different.
I tried to calibrate the velocity by changing the coefficient of friction, but failed
What changes should I make to the cas file to solve this problem?
regards

Attachments:

The administrator has disabled public write access.

TIDE 5 years 11 months ago #32296

c.coulet
OFFLINE
Moderator
Posts: 3722
Thank you received: 1031

Hi
According to your steering file:
You choose
COEFFICIENT TO CALIBRATE TIDAL VELOCITIES : 1.10
So you could change this value to better calibrate your model...

You could also add some diffusion at the velocities of changind the turbulence model.

What is strange is your friction coefficient (except if you manage it in the geometry file) because 5 for a Strickler law is a very rough bottom.

Regards

Christophe

The administrator has disabled public write access.

TIDE 5 years 11 months ago #32333

nadi OFFLINE Junior Boarder Posts: 37	Dear c.coulet thanks for your response I tried other friction laws but did not make a difference How can I apply turbulence to the model?
	The administrator has disabled public write access.