TELEMAC-MASCARET Forum: Error using condim.f for different intial water depths (1/1)

Welcome, Guest

TOPIC: Error using condim.f for different intial water depths

Error using condim.f for different intial water depths 5 years 9 months ago #32920

Wuppukondur
OFFLINE
Junior Boarder
Posts: 53

Hi, I tried to initialize different water depths in different regions in TELEMAC2D. I'm using the fortran code from "Malpasset" example to modify and initialize different water depths in two regions separated by a line. However, I'm encountering the following error as attached. What could be the possible error? I've tried with combination of "initial condition" with "Zero elevation/zero depth/constant elevation/depth/SPECIFIC" but doesn't seem to resolve the issue.

Attachments:

telemacerr...2-18.jpg (172KB)

The administrator has disabled public write access.

Error using condim.f for different intial water depths 5 years 9 months ago #32921

amanj2013 OFFLINE Expert Boarder Posts: 211 Thank you received: 24	Hi, It seems your using an old FORTRAN file with the new Telemac version and this is incompatibility between old and new version. If your using a new version of Telemac for example V7P2 and up. try to use the standard template at the calling subroutines and library rather than the old one. Pls share your files and which version u using now, it may make easier to help you here. AMANJ
	The administrator has disabled public write access.

Error using condim.f for different intial water depths 5 years 9 months ago #32924

Wuppukondur OFFLINE Junior Boarder Posts: 53	Hi Amanj, thanks for prompt reply. I tried using the corresponding subroutines with correspondning version of telemac and it now works.
	The administrator has disabled public write access.