open TELEMAC-MASCARET The mathematically superior suite of solvers

hi,
i am a beginner in Telemac. i tried simulating some cases with tidal boundary, discharge boundary etc. Now i am trying to simulate boundary forced with wind also. i prepared entire setup but error is showing as in the attachment. But the same setup worked for other person with the same version. I want to know what is happening in my system. am trying to attach my simulation file also. but since size is bigger its not happening.

i can mail the setup if someone is fine to check it.

Hi
There is a problem with your wind file
Check it before using it and after, check when the problem occur
DEBUGGER = 1 in the steering file
This will help you to understand where the problem comes from

Regards

i will check that way. thank you sir.

i tried with debugger option in the steering file and now i get error location. i have attached the error. i have no idea how to correct this error. Could you please help me?

Check the name of meteo variables in your meteo file with the name in the file meteo_set_var_names.f
There is probably a difference which leads to your problem

Regards

sir i dont understand much where to change these. can you please help me. i am attaching Meteo_se_var_names.f and my meteo file with this.

What are the names of the variables in your meteo file?

since i am a beginner in using telemac. i don't know how to check these meteo files. if possible can you help me. How should i edit meteo.f file for my use?

In your steering file, did you declare a meteo file or not?
I don't speak about the meteo.f source file, I speak about the meteo data file