open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear all,

I am modeling a bridge with two culverts in TELEMAC-2D (v7p2). The problem is that as soon as I add the keyword ''NUMBER OF CULVERTS'', I receive the following error message:



When I remove this keyword, the program runs but there is no water flowing through the culverts. I have attached the files to this message too. I wonder if you might be able to help me with this issue.
Thank you so much.

Hi
The problem seems to be located when reading the parameter of the first culvert.
There was change in v7p2 with addition of parameters in the data file.

Have a look into the subroutine lecbus.f to see all data required.
Even you don't want to use those parameter according the fact you indicate type=1 in the steering file, you should at least put some 0 in the data file to ensure a correct read

Regards

Thank you so much for your help. I tried it and it is working perfectly now.