TELEMAC-MASCARET Forum: error with TELEMAC 2D (1/1)

Welcome, Guest

TOPIC: error with TELEMAC 2D

error with TELEMAC 2D 5 years 7 months ago #33431

Elsa

Hello,

I have an error with my TELEMAC 2D v7p1 at the launch of the simulation.
The error message is:

================================================================================
ITERATION 0 TEMPS : 0.0000 S

Primary job terminated normally, but 1 process returned
a non-zero exit code.. Per user-direction, the job has been aborted.

mpiexec detected that one or more processes exited with non-zero status, thus causing
the job to be terminated. The first process to do so was:

Process name: [[13442,1],12]
Exit code: 2
================================================================================

Do you know what it means?
I wonder if its not my initial conditions...

Thank you for your help!

The administrator has disabled public write access.

error with TELEMAC 2D 5 years 7 months ago #33432

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi This means a crash in one of the parallel process. Try to run the simulation in sequential mode to check if its directly related to your case or if it's related to parallel computation... Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: Elsa