open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi, dear masters of telemac.

I don't want to re-post questions on the same subject again, but no one reply me, i just try to make your attention again. so sorry guys.

For the Gulf tide, I seted up a new mesh at the same location in Spain. I also gave basic parameters based on the manual and example "tide" of TPXO, and it runs smoothly.

However, the result of the "free surface" is very BAD. It is obviously not on the normal level at the Geo-Bottom, and the water level is much higher. This is very unnormal water flow, I thought.

But for H and UV with open boundary, I did n’t give any values. These values ​​are all from the TPXO database, right? and i already checked the UTM coordinates. So what should do check my model and improve it rightly.

I am very confused about this, I will attach a BK post-pre photo that compare it with the example "tide".(you can see the obvious error), my output file, and steering file. If you need to check more files of my simulations, please let me know

thanks a lot!
All regards
Yang

Hi
You don't want to re-post question but you do it even this break one of the rules of the forum...
We could ban you if you continue to act in this way...

Answering to the forum is not an obligation...
Sometimes there is no answer because the question is not clear.
There is no "obvious" error on the picture you join.
We don't know your model, we don't know whqt you're looking for...
Illustrate an error means clearly show a result with a measurement.
There is some parameters related to tide in telemac. Maybe you should look carefully on these values for your case

Regards

Hi

I am deeply apology for this, i knew these rules still break it, its totaly my fault.I accept your blame, you can delete this post.

I hope you can forgive me for this mistake and i will not continue to do like this.
Getting help on the Forum is a very grateful thing and I appreciate it sincerely.

all regards
Yang