TELEMAC-MASCARET Forum: bottom of friction (1/1)

Welcome, Guest

TOPIC: bottom of friction

bottom of friction 4 years 3 months ago #36595

haozailao
OFFLINE
Senior Boarder
Posts: 86
Thank you received: 1

Hello everyone
I have a question about keyword bottom of friction.
In my simulation, i have set friction value in my geometry file, but it still need me to set the value of keyword 'bottom of friction'.
However i set different value to the keyword 'bottom of value',the results look the same.
Is it means telemac had read the bottom of friction in my geometry file and I just need tot set a meaningless value to the keyword 'bottom of friction' to make the program run sucessfully?
Thanks advanced!

The administrator has disabled public write access.

bottom of friction 4 years 3 months ago #36596

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Yes you well understand the way telemac works with friction coefficient The keyword should exist but it was automatically overwrited by the value in the geometry file if it exists Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: haozailao