open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello,

For a student project, me and my teamates use Telemac 2D and Sisyphe. The goal is to model silting up of a port.

Firstly, we try to run Telemac 2D alone. We did our mesh on BlueKenue. We have 2 liquid borders and 2 solid borders. We have as boundaries conditions a fixed flow at the right liquid border and an fixed water level at the left liquid border.

When we run Telemac 2D, we don't have any flux at borders. We don't understand why.

attached our CAS, mesh and boundaries condition files and a screenshot of the computation.

Thanks For your help

Hi
Try to look at the notebooks in order to visualize your mesh and the associated boundary conditions!
Your result is fully logical as you requested for 0 discharge and 0 elevation at the boundary and as the initial solution is 0 everywhere, this solution is valid

To be clearer, the prescribed values are on the wrong boundary

Regards