open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi all,

I am thinking about finding a way to specify different elevations for every nodes of my boundary.And I refer to the #749 instructions to modify my fortran files,but I still get an error.I attach my files if somebody could help me to find a solution.



Thanks

bc.liq file is missing...
which telemac version did you use?

Thank you for quick reply and sorry for missing the bc file. I use the v8p2 version.

Hi
I found the error is as follows.But I only have one flowrates boundary and don't know why.
Q : MORE PRESCRIBED FLOWRATES
ARE REQUIRED IN THE PARAMETER FILE
AT LEAST 1 MUST BE GIVEN
Regards

You could try to add the following keywords in your steering file :
PRESCRIBED FLOWRATES =
PRESCRIBED ELEVATIONS =
The keywork will be read, but telemac will consider the values in the liquid boundaries file if you use this keyword as you have done.
You can find attached an example of the steering file, along with a liquid file.
You should do something like that and paying attention to the limit of caracters of 72 by lines.


Hope this helps,

Here is the liquid file used (failed to upload)

Hi jtravert,
Thank you for your advision and I will try this.