open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello everybody,

I run a model with 4 boundaries, 2 inlet boundaries are prescribed with inlet discharges by liquid boundary file, and the other outlet boundaries are defined by stage-discharge curves. But I always cannot run the case successfully. Please give me some suggestions, thank you so much.

Good morning Ding,

I would suggest, you give us more information about the problem, because we may not be able to reproduce the problem with the missing geometry file (or include it).

However, when trying your case with another geometry, there seem to be a problem with the "rating_curve.txt" with the simulation stopping at the initialisation of the stage-discharge curves step (Can you confirm it?).

If this is the problem you encountered, it is probably due to line breaks at the end of your txt file. You can find in attachment the updated file (but for next times pay attention to not leave extra blank lines at the end of the file).

Kind regards,
Jean-Paul

Hello jtravert,

Thank you so much for suggestion. I have solved the problem. It is because that there is a problem with the 'rating_curve.txt', so the simulation always stoped at the initialisation of the stage-discharge curves step.

Once again, thank you very much for your time.