open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello everybody,

When I lauch my simulation I have the screnn in the first *.jpg







Also I would like to know , on the second *.jpg, if I have to put the boundary
on the Bottom mesh (the red one), or the multi-colored with the bathymetrie?







Thanks In advance

Best Regards

Hello sobo634,

I am not sure I have understood your two questions.

About your first figure, are you running a parallel computation? If not, I wonder how you can have an element with a number greater than 2,000,000,000! (maybe a record for Telemac-2D?) while the number of elements is 9,878.
Are you sure that you have generated your mesh correctly? Have you used BK?

The geometric file contains connectivity information (e.g. IKLE array), the mesh coordinates X and Y and the bottom elevation for every node. Your 2nd figure is only a view, the mesh contains both information (red and multi-colored with bathymetry).

I hope I have understood you,

Chi-Tuan

Hello Chi-Tuan, Hello everybody,

I am not running a parrallel version.

About the boundary condition, why I give the type of boundary condition on
Blue-Kenue, shall I use the Mesh with the Bathymetrie (multicolored)
or the red one.Which file use ?

Thanks in advance
Best regard

sobo634

Hello sobo634,

I am not a BK user sorry. Have your read the manual or read BK section on this forum? I think you should be able to find by yourself, many other people seem to use BK with success.

Regards,

Chi-Tuan