TELEMAC-MASCARET Forum: constant elevation of value 0 in output result (1/1)

Welcome, Guest

TOPIC: constant elevation of value 0 in output result

constant elevation of value 0 in output result 11 years 10 months ago #6984

gourish

Hi,
I am running a telemac 2d simulation of an estuary.
I have imposed tidal level for boundary condition as the mouth of the estuary.
However after running the simulation, the result file gives a constant water level of 0 for all time steps.

Is it because I have given PRESCRIBED ELEVATION = 0 in the case file ?
I have attached the complete simulation files.

Thanks,
Gourish

File Attachment:

File Name: MaheCase.rar
File Size: 475 KB

The administrator has disabled public write access.

constant elevation of value 0 in output result 11 years 10 months ago #6987

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi As youhave only one liquid boundary in your model, you should have SL(1) instead of SL(2) in your liquid boundary file. In your case, SL(2) is sever requested by telemac so the liquid file is nto used and the prescribed value for the boundary is taken in the steering file and is equal to 0... Hope this will solve your problem
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: gourish