open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi all,

After compiling Telemac with gfortran and python (on a Windows Vista machine), I tried to run a case: as shown on the log herewith, the input files are correctly copied to a temp folder but the compiler then crashes.
Can anyone tell me what are the missing input files? Is it a problem with the systel.cfg file? the paths? something else?

Cheers,
C.C.

Hello,

It looks like your gfortran command is incomplete (a ';' somewhere?). Can you share your systel.cfg with us ?

Note that you should be able to run TELEMAC-2D with the commandinstead of
Thanks.
Sébastien.

Good afternoon Sebastien,

Please find attached the systel.cfg file.

C.C.

Can you check the command in the file:

C:\TELEMAC\V6P2\telemac2d\tel2d_v6p2\wingfortrans\*.cmdo and *.cmdx ?

Are these complete ?

Hello,

I may have found something -- this was hard to pin point. Can you replace -o3 by -O3 in your config's gfortran command line ?

You will have to recompile the whole system. Please let me know.

Hope this helps,
Sebastien.

Hello,

I have finally completed the installation and compilation of Telemac v6.2. Both your hints were useful (systel.cfg had 2 mistakes, an unwanted end of line and an -o3 instead of -O3).

Thanks a lot!
C.C.