Dear TELEMAC community,
I am having trouble utilizing control sections in my parallel Telemac2d simulation. The simulation runs fine without the control sections (10 in total) and it's throwing an error during the runcode.py function. The error message I get is as follows:
LISTING OF TELEMAC-2D ------------------------------------------------------------------------------
TTTTT EEEEE L EEEEE M M AAAAA CCCCC
T E L E MM MM A A C
T EEE L EEE M M M AAAAA C
T E L E M M A A C
T EEEEE LLLLL EEEEE M M A A CCCCC
2D VERSION 6.2 FORTRAN 90
WITH SEVERAL TRACERS
COUPLED WITH SISYPHE AND TOMAWAC
********************************************
* LECDON: *
* AFTER CALLING DAMOCLES *
* CHECKING OF DATA READ *
* IN THE STEERING FILE *
********************************************
EXITING LECDON. NAME OF THE STUDY:
FRASER RIVER HPG
OPENING FILES FOR TELEMAC2D
*****************************
* MEMORY ORGANIZATION *
*****************************
READGEO1: TITLE= newSelafin
NUMBER OF ELEMENTS: 31204
NUMBER OF POINTS: 15838
MXPTEL (BIEF) : MAXIMUM NUMBER OF ELEMENTS AROUND A POI NT: 8
MAXIMUM NUMBER OF POINTS AROUND A POINT : 9
SEGBOR (BIEF) : NUMBER OF BOUNDARY SEGMENTS = 470
INCLUDING THOSE DUE TO DOMAIN DECOMPOSITION
CORRXY (BIEF):NO MODIFICATION OF COORDINATES
MESH: MESH ALLOCATED
POINT_TELEMAC2D: SECTIONS DEFINED IN THE SECTIONS INPUT FILE
recollectioning: T2DRES
STOP 0
moving: ctrl_section_output.txt
runCAS: I could not copy the output files back from the temporary directory:
/cygdrive/c/opentelemac/fraser_calibration_files/fraser_calibration_hot_start.cas_2013-05-11-03h01min00s
|processECR: did not create outfile: results_calibration_with_wse_ramp.slf (T2DRES)
I've increased NSEMAX within flusec_telemac2d.f and updated the format accordingly for fluxpr_telemac2d.f to accommodate several control sections.
Any idea what could be causing this?
I've attached my control section input file and CAS file for reference below.
Thank you,
Chris
