open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,

I obtained the following error while running telemac-2d:

ELEBD: ERREUR DE NUMEROTATION DE L'ELEMENT:********
CAUSE POSSIBLE :
LE FICHIER DES CONDITIONS AUX LIMITES NE
CORRESPOND PAS AU FICHIER DE GEOMETRIE

In english (translate by me...):

ELEBD: NUMEROTATION ERROR OF THE ELEMENT: ******
POSSIBLE CAUSE :
BONDARY CONDITION FILE DO NOT CORRESPOND
TO THE GEOMETRY FILE

However, I use the same file to create the geometry and the bondary condition file. Could you give me any idea why this happened?

Thank you!

Philippe

p.s. I join the GEO.slf, FOND_BC.b2 et FOND_BC.cli used.

Sorry, I could not upload the GEO.slf file because it exceeds the maximum size allowed.

Hello Philippe

have a glance on the following post, your problem seems to be close to the one discussed there.
www.opentelemac.org/index.php/kunena/blu...bmeshes?limitstart=0

With my best regards

Riadh ATA

Hi riadh,
Thank you for your answer.
I looked at the post, however I do not use soft lines to create my mesh.
Here, I join the t3m file used.
Thank you again for your help!

Hello Philippe

I can't use the T3m file you've sent, instead, send me the geo file and the whole model you're using. my mail address is riadh (dot) ata (at) edf (dot) fr.

Moreover, tell me which version of Telemac are you using?

With my best regards

Riadh

Sorry for the delay of my response.

I found the answer to my question. My mesh had some very flat element that cause the problem. I corrected the mesh and everything work fine!

Thank you for your time...