TELEMAC-MASCARET Forum: Problem Running simulation (1/1)

Welcome, Guest

TOPIC: Problem Running simulation

Hello everybody,

i have a problem with simulation

FILES

File Name: h92cbffd.cas
File Size: 3 KB

File Name: h751e9ae.slf
File Size: 778 KB

File Name: ha92c6d1.cli
File Size: 50 KB

STAGE-DISCHARGE CURVE

File Name: h901c0a9.txt
File Size: 1 KB

It's something wrong in the mesh that i have generate?
How can i resolve the problem?

Best Regards,

Stefano

The administrator has disabled public write access.

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi This problems is always the same and a large number of posts gives the solution! The boundary where you impose the discharge is dry! Telemac cannot impose a discharge on a torrential boundary (you should also impose the water height) If the flow is not torrential, you should take care to have some water on this boundary (with the initial condition) Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: StefanoOdapS

StefanoOdapS	How can i impose the water heigth? I'm using fudaa-prepo for do this, but I can not figure out where you change this parametrer. Can you help me? Regards
	The administrator has disabled public write access.