open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi

I'm running TELEMAC2D in parallel and it fails, when I look inside partel.log it says:

PARTEL_ELEBD: ERROR OF NUMBERING IN THE ELEMENT: 0
POSSIBLE REASON: THE BOUNDARY CONDITION FILE IS NOT RELEVANT TO THE GEOMETRY FILE

The boundary conditions file is definitely the correct one for the mesh, so does anyone know what else can cause this problem?

Thanks

Fay

Hi fay
Did you have a transfer between PC and cluster somewhere in the chain?
It could be a problem of conversion...

Regards

Yes I created the mesh and boundary conditions on a windows PC and transferred them to a Linux cluster, I used dos2unix on the .cli file, is there anything else I should do to ensure a correct conversion? Normally I don't have to do anything.

Regards

Fay

Hi
You could check your .CLI file on linux with an editor (like vi) to see if it look like OK.
If it's a large file, sometimes the transfer in ASCII mode could fail (I've experienced this problem once).
Another test you could do easily is to try to run in scalar mode, this allow you to see if the problem is in the file or in the domain decomposition.

Regards