TELEMAC-MASCARET Forum: cas file (1/1)

Welcome, Guest

TOPIC: cas file

cas file 10 years 8 months ago #12303

Aqleema Shah

Hello all,
m stuck in the simulations.
the simulation is running correctly but the output z not correct.. apparently a problm with the parameters in .cas file.
what is the value to be given for 'coefficient to calibrate sea level'...??
if i give default value of zero.........my output reduces to zero in every iteration....
if i giv an integer, the output will b (actual value+the integer)...
how to sort it.....

thnx,

The administrator has disabled public write access.

cas file 10 years 8 months ago #12306

abernard OFFLINE Expert Boarder Posts: 210 Thank you received: 45	Hi, "coefficient to calibrate sea level" is the mean sea level relative to your vertical datum.
	The administrator has disabled public write access.

cas file 10 years 8 months ago #12307

Aqleema Shah	thnx fo reply so giving the default value f zero wont work?
	The administrator has disabled public write access.

cas file 10 years 8 months ago #12308

abernard OFFLINE Expert Boarder Posts: 210 Thank you received: 45	No, The default value works in most case (default values are not wrong). The keyword may be used to set the mean sea level in the same vertical reference than your bottom (it may be chart datum or national vertical reference...). coefficient to calibrate sea level is a real...
	The administrator has disabled public write access.