TELEMAC-MASCARET Forum: T2DCLI error even though running in serial mode (1/1)

Welcome, Guest

TOPIC: T2DCLI error even though running in serial mode

T2DCLI error even though running in serial mode 10 years 4 months ago #13792

TimN
OFFLINE
Senior Boarder
Posts: 67

Dear Forum,

I got an error which I can't handle. It says:

runcode::main:
/Users/opentelemac/v6p3/Lymington/NewNested:
|runCode: Fail to run
|/Users/opentelemac/v6p3/Lymington/NewNested/Steering.cas_2014-07-25-11h45min13s/out_telemac2d
|~~~~~~~~~~~~~~~~~~
|At line 116 of file /Users/opentelemac/v6p3/sources/utils/bief/leclim.f (unit = 7, file = 'T2DCLI')
|Fortran runtime error: End of file
|~~~~~~~~~~~~~~~~~~

I checked the fortran file and from there it seems like something is wrong with my boundary. But I can't figure out what's wrong. Attached you can find my boundary files and the geometry

Cheers, Tim

Attachments:

Boundary.cli (283KB)

The administrator has disabled public write access.

T2DCLI error even though running in serial mode 10 years 4 months ago #13793

TimN OFFLINE Senior Boarder Posts: 67	Sorry, I can't upload the other files, I'll put a picture instead Attachments: Boundaries.png (87KB)
	The administrator has disabled public write access.

T2DCLI error even though running in serial mode 10 years 4 months ago #13794

jmhervouet	Hello, It seems a mismatch between the geometry and the boundary conditions file. You can check the number of boundary nodes if it is given in the listing, and the number of lines in your file, there is probably a difference. Regards, JMH
	The administrator has disabled public write access.

T2DCLI error even though running in serial mode 10 years 4 months ago #13796

TimN OFFLINE Senior Boarder Posts: 67	Thank you, I'll try to correct this. It seems like somewhere off from my domain there were some small islands which I didn't delete. Tim
	The administrator has disabled public write access.