open TELEMAC-MASCARET The mathematically superior suite of solvers

My simulation is mysteriously crashing. I get the error "simulation failed" after the first iteration. See attached for complete terminal output. What could be the reason for this crash? I am given very little information to assist my troubleshooting. I have enabled extra info about solver (INFORMATION ABOUT SOLVER = YES). Are there other techniques to assist in troubleshooting?


Much appreciated,
Simon

Hi Schaad

If you look carefully in the listing, you will see that the problem is located in the subroutine flusec_telemac2d.

This means a problem with the file which contains the description of the control section.

Hope this helps

PS: Think to update your profile!

Thank you, that does help! I troubleshooted the control file by commenting different lines and simplifying the case. I discovered the problem was with the 'sections input file'. I removed that and it works. Much appreciated!