open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear all,
I'm using Telemac 2d, version v6p2. I can define many sources in parallel mode. But it not runs in scalar mode and just allows to have one source!. That's true? With version v6p0, I have defined 5 sources in scalar mode. It runs seem correctly. What happen with version v6p3? Anyone give me an explain? Thank you in advance.
Best regards
Thong NGUYEN
HCMUT, VN

Hi
Strange, and not logical!
Did you have an error message?
Or did you use an adapted fortran subroutine?

regards

Dear Mr. C. Coulet
Yes, I have my fortran but I don't know which subroutine could cause problem? I send you the message when I launch my simulation in scalar mode. I already have verified all point source in exact coordinates of network. Thank you very much for your quickly response.
Best regards
Thong NGUYEN
HCMUT, VN

Excuse me, I send you attached file (in pdf !)
Thank you

In fact your second source is located outside your model!
You have to check the locations (coordinates) of the 2nd source.
French message "POINT SOURCE 2 HORS DOMAINE" in your DOS screen

Regards,

Hello,

Yes, in the next version the parallel version will stop also for the same reason.

I also notice in your listing that we have a format that is too short for writing point numbers of boundaries, We'll correct that.

With best regards,

Jean-Michel Hervouet

Well the format is 1I6, do you have more than 999999 boundary points ?

JMH

Thank you very much for your consideration, Mr. J-M-Hervouet.
Best regards
Thong NGUYEN
HCMUT, VN