TELEMAC-MASCARET Forum: WATER QUALITY MODELING (2/2)

Welcome, Guest

Page:
1
2

TOPIC: WATER QUALITY MODELING

WATER QUALITY MODELING 9 years 5 months ago #17216

jparisi OFFLINE Admin Posts: 114 Thank you received: 56	Hi, delete all folders and files except metis, mingw34, mpich2 and python27. Next, follow step by step the instructions there: wiki.opentelemac.org/doku.php?id=instruc...tomatic_installation Juliette
	The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17218

ams	Hi, When I go to the link its showing : This topic does not exist yet You've followed a link to a topic that doesn't exist yet. If permissions allow, you may create it by clicking on “Create this page”.
	The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17219

jparisi OFFLINE Admin Posts: 114 Thank you received: 56	well I am not sure I can help you with that. it works fine for me try again? wiki.opentelemac.org/doku.php?id=instruc...tomatic_installation
	The administrator has disabled public write access. The following user(s) said Thank You: ams

WATER QUALITY MODELING 9 years 5 months ago #17221

ams	I am able to view that page now. Thanks a lot. I will follow the instructions given.
	The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17224

Hi,
Thanks a lot. The compilation worked fine.
When I tried to run the waq example I am getting this message.

I used the command : runcode.py telemac2d t2_waq_o2.cas
Is that the way to run the water quality file ? I found two cas files in the example folder "t2_waq_o2.cas" and "o2_waq_steer.cas".
In telemacv6p2, for hydrodynamic modeling I use runcode.py telemac2d cas_filename.txt for running the code.
What am I supposed to do ? Please guide me.

The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17225

jparisi
OFFLINE
Admin
Posts: 114
Thank you received: 56

An easier command line would be

telemac2d.py t2_waq_o2.cas

You are trying the run a test case configured in parallel with a scalar configuration.

You should comment the line "PARALLEL PROCESSORS = 8" in the steering file. Or you could try to install manually the parallel configuration.

Also, please read the user manual:
www.opentelemac.org/index.php/validation...-user-manual-en-v7p0

Hope this helps
Juliette

The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17229

Thankyou. That worked .I was able to run the example. Now I tried with my modeling case. I wrote the steering file in same format as in the example file but it does not run . Instead I am getting this message.

I am attaching my steering file.

File Attachment:

File Name: run_01.cas
File Size: 6 KB

and waq steering file

File Attachment:

File Name: waq_steeringfile.cas
File Size: 3 KB

Kindly take a look into it.

The administrator has disabled public write access.

WATER QUALITY MODELING 9 years 5 months ago #17230

riadh	Hello In your steering file, you have lines with more than 72 characters, this could generate lots of troubles. with my best regards Riadh
	The administrator has disabled public write access.