open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,

I have a model with one upstream boundary discharging water at 43 cms and two downstream boundaries. Right before the the downstream boundaries, I modeled weirs. However, when I compile, the upstream boundary is at 0 cms, and only one of the downstream boundary is reacting. It was working well before I added my weirs. Any idea what is happening?

Hi
Hard to say without anymore info
Why did you said you compile? you means running the simulation?
You should take care that you should have water on de downstream side of weirs to allow Telemac to impose a discharge...
Regards