Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TELEMAC-2D
Simulation of telemac2d with float
Flat Threaded

TOPIC: Simulation of telemac2d with float

Simulation of telemac2d with float 8 years 5 months ago #21768

  • nguyenthong_BK
  • nguyenthong_BK's Avatar
Dear all;
I'm using telemac2d, version v7p0r1 in parallel mode with 4 processors. I launch my program with one float. It failed after about 4 hours of simulation with the message :"...THE NUMBER OF TRACEBACK INTERFACE CROSSINGS IGEN >99" (see attached file). I don't know what does this means? Does anyone have any suggestion for me? Thank you very much in advance.
P/S: The simulation without the float runs normally.
Best regards
Thong NGUYEN

File Attachment:

File Name: Doc1.pdf
File Size: 129 KB


HCMUT, VN
The administrator has disabled public write access.

Simulation of telemac2d with float 8 years 5 months ago #21771

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
Hi

This means you encountered a problem with the method of characteristics for your float. During 1 time step, the float crosses more than 99 interface of sub-domain...
This means you probably have a problem somewhere in your hydrodynamic result...

Hope this helps
Christophe
The administrator has disabled public write access.

Simulation of telemac2d with float 8 years 5 months ago #21772

  • nguyenthong_BK
  • nguyenthong_BK's Avatar
Hello;
Thank you very much for your prompt response.
Best regards
Thong NGUYEM
The administrator has disabled public write access.
Flat Threaded
Moderators: pham
Forum
System Modules
TELEMAC-2D
Simulation of telemac2d with float

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.