TELEMAC-MASCARET Forum: Retain the tracer value of pre. simulation in Telemac2d, version v7p0 (1/1)

Welcome, Guest

TOPIC: Retain the tracer value of pre. simulation in Telemac2d, version v7p0

Retain the tracer value of pre. simulation in Telemac2d, version v7p0 8 years 5 months ago #22186

nguyenthong_BK

Dear all,
I'm using telemac2d, version v7p0 with one tracer. When I launch my simulation with options : COMPUTATION CONTINUED =YES and INITIAL TIME SET TO ZERO =YES, I noted that the hydrodynamics parameters of previous simualation are only retained, not for tracers values. My question is how do I must modify (in steering file or fortran file) for retain the tracer value of previous simulation? Thank you very much for any your suggestion.

P/S: I don't have this issue when I use telemac2d, version v6p3

Best regards
Thong NGUYEN
HCMUT, Viet Nam

The administrator has disabled public write access.

Retain the tracer value of pre. simulation in Telemac2d, version v7p0 8 years 5 months ago #22189

jmhervouet	Hello Thong, This is a known bug corrected in version 7.1. In telemac2d.f look for 31+ITRAC and put instead 33+ITRAC. This is due to the introduction of two variables for secundary currents, before the tracers in the block VARSOR. With best regards, Jean-Michel Hervouet
	The administrator has disabled public write access.

Retain the tracer value of pre. simulation in Telemac2d, version v7p0 8 years 5 months ago #22190

nguyenthong_BK	Hello Mr. J. M. Hervouet, Thank you very much for your help. It's solved the problem. With my best regards Thong NGUYEN VN
	The administrator has disabled public write access.