open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear friends,

I am encountering a problem while trying to couple T2D and Sisyphe.
The image of the error is attached. I have seen one or two people here, having the similar error, but I couldn't find the solution.

When I run the same steering file for some another domain, the simulation works. Is this error related to the mesh and other input files?

The .slf file and steering file are also attached.

Thank you.

Regards,
Saroj

Not sure but there is no geometry file declared in the sisyphe steering file...

Dear Christophe,

There is the geometry file defined in the sisyphe steering file sisy.cas . It is a bit down the page. May be you missed to see that.


Regards,
Saroj

You're right, I missed it.

You should give the result file of sisyphe computation

Dear Christophe,

The error says 'out_telemac2d.exe' has stopped working. As you suggested, I gave the results file in the sisyphe steering file. but the problem persists. This time the error is different.
I have attached the necessary files. Could you check it once?

Regards,
Saroj

Now it's a problem with sisyphe computation I think.
I'm not able to identify the problem without trying to run your case
regards