open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi, I am running morphodynamic simulation using Finite Volume Method (FVM) and I have a problem with Sisyphe graphic printout. Results of Telemac 2D simulations looks good, but results of Sisyphe does not display right in time in BlueKenue. If I switch to FEM, the results looks good, but I need to use FVM.
I tried to run some Sisyphe examples with FVM and the results are same as in my simulation, so it looks that FVM is the issue here.

The problem is similar to this topic, but this is the only one I found on the forum and there is no solution yet.
www.opentelemac.org/index.php/assistance...c-2d-fvm-and-sisyphe

I have attached my simulation files.

Best regards

Michal

I solved the problem. I used to run the simulations in v7p3, but if use v7p2, the results displays as it should.