TELEMAC-MASCARET Forum: Bed Evolution and Sediment Classes printout error (1/1)

Welcome, Guest

TOPIC: Bed Evolution and Sediment Classes printout error

Bed Evolution and Sediment Classes printout error 3 years 11 months ago #37289

kareemjo94

Hello Everyone,

I have an issue with post processing the results I am getting from coupling GAIA with Telemac2d.

I have 3 different suspended sediment classes. The simulation seems to run just fine. but the results file doesn't show any sediment related results such as sediment transport or bed evolution on Blue Kenue apart from U and V.

Thank you in advance

Attachments:

The administrator has disabled public write access.

Bed Evolution and Sediment Classes printout error 3 years 11 months ago #37323

pavans
OFFLINE
Moderator
Posts: 46
Thank you received: 17

Hello,

which version are you using?

There are several points:
- can you try to add 'T1,T2,T3' to the list of VARIABLES FOR GRAPHIC PRINTOUTS in your hydrodynamic steering file please? This is because suspended sediments are seen as tracers and their concentrations are printed in the hydrodynamic result file.
- can you try to run run_selafin.py scan res_file ? This will print the variables of yours result files
- why do you set 'ADVECTION OF TRACERS = NON'?

Hope it helps,

Best regards
Sara

The administrator has disabled public write access.

The following user(s) said Thank You: kareemjo94

Bed Evolution and Sediment Classes printout error 3 years 11 months ago #37331

kareemjo94	Hello, I am using v8p1. adding T1,T2,T3 to the hydrodynamic steering file did the trick. Thank you very much. Best Regards Kareem
	The administrator has disabled public write access.