Welcome, Guest
Username: Password: Remember me

TOPIC: Error Coupling Telemac 2D and Sisyphe

Error Coupling Telemac 2D and Sisyphe 2 years 4 months ago #40640

  • Jarryleo
  • Jarryleo's Avatar
Hi everyone !

First post for me, because in the 7 years i used Telemac, i always found the solution to my problems on this very forum.
This time, i tried to do a Telemac 2D/Sisyphe coupling in a river, but it doesn't seem to work whatever i do.

I tried mutiple things i've found on the forum so far :
- Launch the simulation without the coupling ==> it works just fine
- Launch some of the sisyphe examples i have in the opentelemac folder ==> They all work fine
- Copy the structure of the files i have in the examples ==> The simulation doesn't start.

Maybe i'm not launching the simulation the right way. You have the command i use in the attached files.

You'll find all of the files i use (it's a hotstart for other simulations) and the message i got when i use the DEBUGGER = 1.
The parameters (like sediment diameters) are quite random for now, but i'll change it when the coupling works.

Thanks !
The administrator has disabled public write access.

Error Coupling Telemac 2D and Sisyphe 2 years 3 months ago #40682

  • kopmann
  • kopmann's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 106
  • Thank you received: 65
Hello,

Which version do you use?
Do you have debugger=1 also for sispyhe?
And can you also post your sisyphe-cas file?

Best regards,
Rebekka
The administrator has disabled public write access.

Error Coupling Telemac 2D and Sisyphe 2 years 3 months ago #40705

  • Jarryleo
  • Jarryleo's Avatar
Hello !

Found the problem, my 8.0.0 was in parallel, but all my simulations ran with only one processor.
I just forced the simulation with --ncsize=2 and it worked !

Best regards
The administrator has disabled public write access.
Moderators: Pablo, pavans

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.