open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello,

I had a question about Gaia.
I am doing a simulation based on the tidal flat example.
During the simulation, I get the following error (Figure 0) and then it stops (Figure 3).
I also increase the iterations, but it is useless.
Where is the problem?

Thanks
Sina

Does the computation run without coupling with gaia?

Dear Sina,
it seems that there is no open boundary for the sediment. This could be a reason for the high iterations. In the cli-file the 8th column should be set to 4 or 5 at the open boundaries. Otherwise there is no inflow and outflow of sediments.
Best regards,
Rebekka

hello,
I followed your advice and it worked.
Thank you Rebekka.
sina