TELEMAC-MASCARET Forum: POINT 5 IS ON A BOUNDARY BUT NOT IN THE LIST OF BOUNDARY OR .... (1/1)

Welcome, Guest

TOPIC: POINT 5 IS ON A BOUNDARY BUT NOT IN THE LIST OF BOUNDARY OR ....

POINT 5 IS ON A BOUNDARY BUT NOT IN THE LIST OF BOUNDARY OR .... 1 year 9 months ago #41912

josiastud
OFFLINE
Senior Boarder
Posts: 132
Thank you received: 2

HI EVERYONE,
I already run succesfull 3d simulation with this mesh but when I run coupling with Gaia, I got this mistake... (v8p3r1)

POINT 5 IS ON A BOUNDARY
BUT NOT IN THE LIST OF BOUNDARY POINTS
OR THE NUMBER OF LINES IN THE BOUNDARY
CONDITIONS FILE IS GREATER THAN: 440
NUMBER TAKEN IN THE GEOMETRY FILE

PLANTE: PROGRAM STOPPED AFTER AN ERROR
RETURNING EXIT CODE: 2

How can I manage this please.
thx
Josias

The administrator has disabled public write access.

POINT 5 IS ON A BOUNDARY BUT NOT IN THE LIST OF BOUNDARY OR .... 1 year 9 months ago #41916

kopmann
OFFLINE
Senior Boarder
Posts: 106
Thank you received: 65

Hi Josias,

the error message suggests that the boundary file and the geometry file is not consistent. Did you check if you have the same geo-file and bound-file for gaia and t3d? Start again a t3d only simulation (sometimes files get corrupt by copying). If this is correct then insert gaia. You can also check the mesh itself outside from telemac by using "run_telfile.py --scan geo-file"
And you can use the keyword for t3d and gaia: CHECKING THE MESH

Hope this helps!
Best regards,
Rebekka

The administrator has disabled public write access.

The following user(s) said Thank You: josiastud

POINT 5 IS ON A BOUNDARY BUT NOT IN THE LIST OF BOUNDARY OR .... 1 year 9 months ago #41920

Renault OFFLINE Senior Boarder Posts: 120 Thank you received: 33	Hi Josias, I could be wrong, but maybe the boundary condition file is not set up for GAIA. Having run into a similar problem, I followed instructions from this post (I was using TELEMAC-2D) and it worked: https://hydro-informatics.com/numerics/gaia-basics.html#boundary-conditions Hope this helps, André
	The administrator has disabled public write access. The following user(s) said Thank You: josiastud