TELEMAC-MASCARET Forum: GAIA/T3D: Local scour at the inlet (1/1)

Welcome, Guest

TOPIC: GAIA/T3D: Local scour at the inlet

GAIA/T3D: Local scour at the inlet 8 months 4 weeks ago #44245

ravi
OFFLINE
Fresh Boarder
Posts: 17

Hello Everyone,

I am simulating an experimental flume problem on Telemac 3D/GAIA. I am observing a large amount of scour at just few nodes near one side of the inlet. Due to this localised scour on few nodes at the inlet, my results at the test sections are also effected. I have tried with various cell sizes of 10cm, 5cm, 2cm etc. But the problem doesn't solve.

Also, does using T3 channel mesher for problems dealing with experimental flumes have any advantage over the T3 mesh generation.

The administrator has disabled public write access.

GAIA/T3D: Local scour at the inlet 8 months 4 weeks ago #44249

Renault OFFLINE Senior Boarder Posts: 120 Thank you received: 33	Hi ravi, I would recommend using a non-erodible zone at the inlet. I use the trick in #41943 which consists of slightly changing the roughness coefficient in the desired zone. Hope this helps, André Renault
	The administrator has disabled public write access. The following user(s) said Thank You: ravi