open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear Telemac group:

Following the installation guide from Jose, I tried to install the telemac on my computer. Now, I faced a problem when I did the compilation of parallel installation. The question had been also mentioned in the topic of "Failed compilation for v8p0 paralle" which post two months ago:

www.opentelemac.org/index.php/kunena/2-w...arallel?limitstart=0


At the end, c.coulet pointed that the problem could be : the compiler is not found on the computer. However, there is no solution there.

Could you please help me to fix this problem? I put my cfg file and picture at the end.

Best regards,
Qiang MA
2019-10-23

However, When i tried the suggestion from Jose posted on the

www.opentelemac.org/index.php/kunena/2-w...arallel?limitstart=0

it works at beginning and then the error appeared (see the picture)

Could anyone help me to solve it?

Best regards,
Qiang MA
2019-10-23

Hi,

There seems to be an issue with your gfortran.
You should reinstall it.

Hi

As usual, even the problem is well describe in the error message, it seems it's really difficult to read!

it's written "gfortran: error: unrecognize command line option '-03'"

if you takes few seconds to look at compiler options -> gfortran --help
You will find, in the paragraph optimization are -Ox with x the level of optimization require (between 0 and 3)
So if you enter -O3 instead of -03 this will works