open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi all,

I've installed the v8p1r1 version on windows10 using this parallel config file, and the compilation works well



When i tried to run a simulation the mesh was splited but the calculation stops and I get the following error message.



do you have any clue ?
Thank you for your help.

Hi,

This means that a character in the listing is not utf8.
To get the real error go into the temporary folder (baxter_unsteady.cas_2020-10-14-18h...s) And rerun out_telemac2d.exe

Hope it helps

Thank you for your answer,
I rerun out_telemac2d.exe, i get no error message and the calculation runs but only on 1 processor.

do you have any idea of whats going on ?
Thanks,

Hi
you should run the mpiexec command look at the end of your screen shot.
As an additional option, you could also add -localonly in the mpi exec commmand line

Hope this helps