open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,

I'm triyng to compile telemac but everytime I have a runtime Error.

I'm using python27 and g95. You can find de runtime error, my cfg file, and the two versions of g95 and python installed.

Could someone help me ?

Thanks a lot.

Hi
Could you give us more information about your installation?
Which windows?
Use of SVN?
Location of telemac sources file?

Regards

Thanks for this fast answer.

I'm on Windows 7 - 64 bits
using SVN.
for the location of the telemac sources file I'm not sure what you're asking. Everything for telemac was put in C:\opentelemac\v6p2

Ok
What are the first messages printed in the cmd windows before the runtime problem?
Maybe you could redirect the output to a file and join the file here.
I would like to know if the configuration is well recognize.
For me this problem could occur only during the scanning step but you you confirm this point.
Regards

There are too much recursion I can't get back to the top of the output. So I've stop the code (with mark) just before the error and that's what your can see on the picture.

Hi,

Sorry to borrow but I realy need this program installed.

Does someone has an idea for me ?

Thanks a lot.

Hi,

You said you used the SVN version.
What revision are you on?

Could you try to get the full message?
To get the full message just add "> test.log" at the end of your command to redirect the output in a file.

Yoann

Thank you Yoann for this answer.

Here is the test.log, I had already done that but it gives no more result that the picture.
the revision is 3185.

Phil

Just a few other question.
Did you change anything in the code?
Could you try to run first the command below and then relaucn compileTELEMAC.py:
python config.py --delete

Thanks

It doesn't work.
--delete is not an option of config.py

Do you think I would rather install with the pre-compiled binaries ?