open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello!

Visualising my results, the channel edge has jagged/fuzzy edges not present in the mesh. However, the points of these fuzzy edges do match those shown in the "ipobo" file.

Could there be a problem with how Telemac is reading this mesh? i.e. perhaps the boundary nodes are being read incorrect?

I've not had a problem with it before, so it's puzzling. I remade the boundary file, and visualised the mesh using different post-processors (BlueKenue and Paraview).

Results:








Original mesh:

Hello,

Which release of TELEMAC-3D do you use?

Can you try 2 things:
- run run_telfile.py scan name_of_geometry_file and send the listing,
- add CHECKING THE MESH = YES in your steering file (if you use v8p2r1 or the main release) and also send the listing from the command you have run.

Chi-Tuan

Thanks for the reply!

I discovered the issue - a chunk of the mesh nodes weren't matching with the geometry in the results.