open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello, TELEMAC users.

I am now trying to couple TELEMAC and DELWAQ.

Based on the official telemac3d example (delwaq), I applied new .slf and .cli files (a retengle), instead of the duex case. TELEMAC seems to run well, producing .hyd and .waq files. However, when they were coupled with DELWAQ, they lead to a crash at the "Waq (1)" step. When I checked the .lst file, DELWAQ does not seem to properly read/write the boundary conditions (.cli and .inp files). In other words, the .cli file, which I created with BlueKenue) does not seems compatible with DELWAQ.

I wish that I could hear something about the causes of the error and the way to solve the problem. I also have posted necessary files in attachement.

Thank you in advance.

Joon Lee

School of Construction and Environmental Engineering
Kyungpook National University, South Korea

Hello,

I am not a DELWAQ expert but did you remember to change your binary file format from big endian to little endian ?

I believe DELWAQ still work in little endian by default, while TELEMAC work in big endian.

Hope this helps,
Sébastien.