open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear community,

Recently i searched to coupled TOMAWAC and ARTEMIS, with the topics shared before, i found the solution of my problems.

So i had done the following steps:

1- Run the simulation with the keyword below

File with coordinate of spectra to write = 'fichier .txt'
This file indicate the coordinate of the points wich are in the boundary of the ARTEMIS model and correspond to the nodes in the mesh of the TOMAWAC model)

PUNCTUAL RESULT FILE = 'Nom.spe'

This keyword make a output of the result simulation in the boundary points in artemis model.

2- Make the steering file for ARTEMIS.
with the key word of FILE WITH COORDINATE OF SPECTRA IMPOSED My result of TOMAWAC simulation was integrated in ARTEMIS simulation.


The problem is that when i run the ARTEMIS simulation, i got this error:
TOO MANY VARIABLES IN Res_houle.spe

PLANTE: PROGRAM STOPPED AFTER AN ERROR
RETURNING EXIT CODE: 2

job aborted:

I don't know if we can limit the variable in the file.spe?
hope someone can help me.

Best REGARDS.
YASMINA.

Dear all,

For my topic before, i think that my fault is that this method concern the extraction result from large model tomawac to small model tomawac and not for the artemis model.

I had a help from the topic #30584 to coupling ARTEMIS and TOMAWAC.


Hope that help someone.

Best REGARDS.
YASMINA.