open TELEMAC-MASCARET The mathematically superior suite of solvers

HI,

I AM MODELING A RIVER WITH STRUCTURES, INITIALLY RUN THE RIVER WITHOUT STRUCTURES AND ALL WAS NORMAL IN PROCESSING AND ENTERING STRUCTURES (I GENERATE THE MESH WITH BLUEKENUE) AND RUNNING THE MESEL IS GENERATED THE FOLLOWING ERROR:


I COULD EXPLAIN WHAT HAPPENS.



===================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 3527 RUNNING AT node102
= EXIT CODE: 136
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
===================================================================================
YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Floating point exception (signal 8)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions
_____________
runcode::main:
:
|runCode: Fail to run
|/usr/bin/mpirun -wdir /data/Pract/caso3/correr/MALLA2/RIMAC_CAS_REYES.cas_2017-07-11-10h24min03s -n 2 -hostfile ~/mpi_default_hosts /data/Pract/caso3/correr/MALLA2/RIMAC_CAS_REYES.cas_2017-07-11-10h24min03s/out_telemac3d
|~~~~~~~~~~~~~~~~~~
|Program received signal SIGFPE: Floating-point exception - erroneous arithmetic operation.
|
|Backtrace for this error:
|#0 0x7F30AC07BE08
|#1 0x7F30AC07AF90
|#2 0x7F30AB7AD4AF
|#3 0x9DADFC in p_dot_ at p_dot.f:65 (discriminator 12)
|#4 0x895DDF in p_dots_ at p_dots.f:90
|#5 0x9DB067 in gracjg_ at gracjg.f:129
|#6 0x89CA25 in solve_ at solve.f:533
|#7 0x472C1F in wave_equation_ at wave_equation.f:799 (discriminator 4)
|#8 0x5450C0 in telemac3d_ at telemac3d.f:2012
|#9 0x551752 in MAIN__ at homere_telemac3d.f:189
|~~~~~~~~~~~~~~~~~~

Hi
The first thing to try is to run the same computation in scalar mode (not in parallel) to confirm the problem...
Other point, did you use a user fortran?

Regards

At the moment I am not using any fortran files.

I am attaching an image of the framing and structures (pillars)
Now I ran again and I get the following error.
Is it a gating problem?


I'm starting learning with this software.

OK
we should have a look into your steering file.
If this is possible you could join all the file of this case in order to let us test and check
regards

I Send the files

The selafin file, it weighs too much, I'll try to upload it

In this selafin, exits only one structure. but have the same mesh

Hello Reyes,

Have you solved the 'floating-point exception' problem above? I got the same error when running on university HPC, any advice is appreciated.

Yunhao