TELEMAC-MASCARET Forum: Rubens couldn't open telemac-3D result? (1/1)

Welcome, Guest

TOPIC: Rubens couldn't open telemac-3D result?

Rubens couldn't open telemac-3D result? 13 years 2 months ago #2258

qilong
OFFLINE
Expert Boarder
Posts: 340
Thank you received: 33

Morning everyone!

I used telemac-3D to run an validation case "119_stratification". I got the 2D result "r2d_stratification.slf" and 3D result "r3d_stratification.slf". However, I could open 2D result file in Rubens but it didn't open "r3d_stratification.slf". I chose "SERAPHIN_INV" as the format of the result file. The error reads :

Reading and decoding the file E:\TelemacV6\Validation\validation_tel3d_v6p1\119_stratification\r3d_stratification.slf ...
nbv1 nbv2 7,0
iparam1 1
nelem1,npoin1,nppel1,idisc1 44080,24948,6,1
Error: Invalid points number by meshes (6)
Could Not Find E:\TelemacV6\Pre_Post\bin\temp\LecRubens.FLAG

How to view 3D result in Rubens? Thanks a lot!!

The administrator has disabled public write access.

Re: Rubens couldn't open telemac-3D result? 13 years 2 months ago #2261

jmhervouet	Hello, No, Rubens cannot read directly the 3D results, it reads only the 2D results. You can use Blue Kenue, or Tecplot, or using the postel3d program to slice the 3D results into cross-section that can be read by Rubens with format LEO. With best regards, Jean-Michel Hervouet
	The administrator has disabled public write access.