open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,
I've just install telemac v7p0, since I had had problems with v6p3 version. When trying to run a simulation, following the steps in this link wiki.opentelemac.org/doku.php?id=how_to_run_a_simulation , it appears the message attached below.
I will be grateful for any help you can provide.

Hello again,
here is my runcode.py, just in case it has to do with the error I've posted before.
Thank you very much

Thanks for your run code. I was also facing the same issue. Your post is really informative and helpful. Thanks.

outsource iPad development

Thanks for your run code. I was also facing the same issue. Your post is really informative and helpful. Thanks.

outsource iPad development | iOS developer in India

Hello,

you need to make your version of python is 2.7.2 at the very least -- higher if possible. In fact, we recommend that you install canopy from enthought but you can do that later.

Let me know if you already have the correct python.

Sebastien.

Thank you for your response, Sebastien.
The version of python I have is 2.7.5. I'm going to install canopy right now. I hope this works.
Tania

2.7.5. should be OK.
The problem must be elsewhere.

If you install Canopy, on top of an exitsing python, make sure you un-install python first and reboot before the Canopy install.

Sébastien.

Hi Sébastien,
After intalling Canopy, Ive tried to run runcode.py and the error still appears. I attach the errors that Canopy identifies and the runcode.
Thank you very much for your help.

Hi again,
As Canopy first message is "Not able to get to the configuration file: c:\opentelemac\v6p3\configs\systel.cis-windows7.cfg", I've tried to run systel.cis-windows7.cfg to find why it can't compile. I attach the error below. In addition to this, I don't understand why it is working with v6p3 instead of working with v7p0.
Thank you very much, Sébastien.
Tania