open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi everyone

I have a T2D model with a dozen complex culverts modelized with the Masse/Bilan subroutine (on V7P1). This puts a rating curve at the upstream boundary of my culvert island (or downstream of the upstream channel) and a discharge on the downstream boundary, equal to the usptream discharge.

This works great. But now I'm trying to couple that model with sisyphe, for bed load computation. And obviously, the solid discharge is not taken into account on the subroutines combo, so bed loads stop at all culvert islands.

I'm trying to modify the codes to get the solid discharge through the culverts too, but it's a bit too complicated for me and wondering if anyone had a few pointers.

Should I try to write a Qbor computation loop similar to the For/Next codes for liquid discharges imposed boundaries ?

Best regards